Build a Tabletop Game Wheel

Build Instructions

Fabricate: Player Station Bottom, Red (x1)

PLAYERBTM-RED

Items Needed

Materials

Part IDPart NameQty PerTotal Qty (for 1)
PETG-REDPETG Filament, Red0.111 kg0.111 kg

Supplies

Part IDPart NameQty PerTotal Qty (for 1)
TAPE-12Wide Painter's Tape, 12in Wide (per inch)14 in14 in

Tools

Part IDPart Name
PRINTER-3D3D Printer, 300mm or Larger Print Bed
PRINT-NOZZLE-063D Printer Nozzle, 0.6mm
PUTTY-KNIFE-150Putty Knife, 1.5 Inch
FLUSH-CUTTER-600Flush Cutters, 6 Inch
RAGAbsorbent Shop Rag

3D Printing Information

Download Model File FW_PlayerBtm.stl

Download Project File CCR10S_FW_PlayerBtm.3mf

Approximate Print Time: 5h 18m

Recommended Print Settings

  • Nozzle Diameter: 0.6mm
  • Layer Height: 0.3mm
  • Initial Layer Height: 0.3mm
  • Z Seam Position: Front Right
  • Top Layers: 4
  • Bottom Layers: 4
  • Infill Pattern: Gyroid
  • Infill Density: 20%
  • Connect Infill Lines: Yes
  • Print Temperature: 250C
  • Build Plate Temperature: 80C
  • Flow: 100%
  • Initial Layer Flow: 85%
  • Print Speed: 40mm/s
  • Wall Speed: 40mm/s
  • Top/Bottom Speed: 40mm/s
  • Initial Layer Speed: 30mm/s
  • Number of Slower Layers: 1
  • Enable Print Cooling: No
  • Build Plate Adhesion: Brim

Instructions

  1. Print the model using the above settings as a guideline.
  2. Once the print completes, carefully remove the model from the build plate using the putty knife. Removal is easier if the bed is warm. Go beneath the tape under the brim and edge of the model. Use caution and go slow, putty knives are sharp! Do not remove the tape from the print.
  3. Wet the rag and place it on a surface that will not be water damaged. Place the finished print on top of the rag, tape side down. Let sit 2 hours.
  4. Carefully peel off the damp tape.
  5. Remove brim, avoiding use of flush cutters as a first resort. Work the brim from sharper corners, attempting to score the brim at the base of the print. When using flush cutters to clean up remaining brim, try to grab, lift and pull the brim away from the model rather than snipping with the cutters. This will result in smoother edges. Remember that ideally you want the brim to separate from the print at their seam.

Back to Build Instructions

Last updated: 5/18/2024 18:05:38