Fabricate: Player Pointer Shaft, Yellow (x1)

PTRSHAFT-YEL

Part ID	Part Name	Qty Per	Total Qty (for 1)
PETG-YEL	PETG Filament, Yellow	0.006 kg	0.006 kg

Part ID	Part Name	Qty Per	Total Qty (for 1)
TAPE-03	Painter's Tape, 3in Wide (per inch)	14 in	14 in

Part ID	Part Name
PRINTER-3D	3D Printer, 300mm or Larger Print Bed
PRINT-NOZZLE-06	3D Printer Nozzle, 0.6mm
PUTTY-KNIFE-150	Putty Knife, 1.5 Inch
FLUSH-CUTTER-600	Flush Cutters, 6 Inch

Approximate Print Time: 32m

Print the model using the above settings as a guideline.
Once the print completes, carefully remove the model from the build plate by removing the tape from beneath it. The model should pop off fairly easily. If not, use the putty knife to work beneath the tape and free the model. Use caution and go slow, putty knives are sharp!
Remove brim, avoiding use of flush cutters as a first resort. Work the brim from sharper corners, attempting to score the brim at the base of the print. When using flush cutters to clean up remaining brim, try to grab, lift and pull the brim away from the model rather than snipping with the cutters. This will result in smoother edges. Remember that ideally you want the brim to separate from the print at their seam.

Last updated: 5/18/2024 18:05:38